Signed, takes effect January 1, 2027
California balcony solar law: limits, dates and what to tell the utility
California has signed a plug-in solar law that takes effect on January 1, 2027. The limit is 1,200 W. Maximum aggregated AC output per dwelling, not per meter. "Dwelling" is not defined for shared-meter buildings or accessory dwelling units. The law does not require a notice, but it lets the utility ask for one or set up a way to register. Check with your utility. This page cannot check your lease, HOA rules, local codes or wiring.
1,200 WLimit on inverter output, in AC watts
- limit tier
- 1
- signed, 2026
- Sep 30
- takes effect, 2027
- Jan 1
- rules last checked
- Oct 1
Notice: none in the law, but the utility may ask for one.
Statute: SB 868 (Wiener), Chapter 985, Statutes of 2026, Public Utilities Code §§ 8530 to 8532.
The law in California
Portable solar generation device, per dwelling (Public Utilities Code 8530 and 8531): limit 1,200 W.
Dates: signed September 30, 2026, takes effect January 1, 2027.
Source: SB 868 (Wiener), Chapter 985, Statutes of 2026, Public Utilities Code §§ 8530 to 8532, checked October 1, 2026. Update log
Conditions in California's law
| Condition | In California | Source |
|---|---|---|
| The device plugs into an outlet. It is not hardwired. | A receptacle. | PUC § 8530(c)(2) |
| The device must meet the certification or listing requirement in the law. | Certified as a plug-in photovoltaic system by UL or an equivalent laboratory. No standard number named. | PUC § 8530(c)(5) |
| The device must meet the National Electrical Code (and, where the law says so, the state building or electrical code). | The most recent National Electrical Code and the California Electrical Code. | PUC § 8530(c)(4) |
| The device must have a feature that stops it feeding the building or the grid during a power outage. | A certified feature that isolates the device from the building's electrical system. | PUC § 8530(c)(6) |
| The device must be intended to offset the customer's own use of electricity at the property. | PUC § 8530(c)(3) | |
| The law does not itself make the customer notify the utility, but the utility may ask for a notice or registration. Check your utility. | The utility may require a simple online registration of address, make, model and size. It cannot be an approval step. | PUC § 8531(c) |
What California's law does not settle
- The act has no effective date clause. The date follows from the constitutional default for a non-urgency statute (Cal. Const. art. IV, § 8(c)).
- The interconnection exemption (§ 8531) is repealed on January 1, 2030. From January 1, 2030 the sales ban in § 8532 on plug-in devices missing the code, certification and isolation conditions applies.
- The text is silent on landlords, HOAs, local permits and payment for exported power.
Beyond the limit in California
Other terms in the law
- The utility may not require its approval before you install or use the device, any fee or charge related to the device or to the electricity it feeds into the building, or controls or equipment beyond what the device has built in. (Public Utilities Code 8531(b))
- A device that misses any one of the law's conditions does not count as a portable solar generation device and gets none of the law's exemptions. (Public Utilities Code 8531(d))
- The law does not direct the Public Utilities Commission to adopt rules. The commission's interconnection rulemaking lists plug-in solar as an issue that may be addressed in a later phase. (CPUC R.25-08-004, amended scoping memo of March 3, 2026)
Power sent back to the grid
The law neither grants nor denies net metering or export payment. The text does not settle how a utility bills power a device sends to the grid. Net metering in every state
Permits and codes
The law does not address local permits. Its exemption is from "interconnection requirements" only. A device must meet the most recent National Electrical Code and the California Electrical Code to count as a portable solar generation device. Source: Public Utilities Code 8530(c)(4) and 8531(a). Permits in every state
Renters, landlords and associations
The plug-in law says nothing about tenants, landlords, homeowner associations or condominium associations. Source: Public Utilities Code 8530 to 8532. Renters and associations in every state
Check your own kit in California
Estimate for your kit. Not a safety check: ask a licensed electrician about your wiring and outlets.
Expected output in Los Angeles, CA
Under California's 1,200 W figureYour inputs
- Location
- Los Angeles, CA
- Inverter AC rating
- 800 W
- Panels
- 2 x 400 W = 800 W
- Panels in series
- 1
- Direction
- South
- Mounting
- Vertical (on a railing or wall, 90 degrees)
- Rate
- 32.58 cents per kWh
- Used at home
- 100%
Output by month (kWh)
Your kit against California's limit
The law is signed but not yet in force: it takes effect on January 1, 2027. SB 868 (Wiener), Chapter 985, Statutes of 2026, Public Utilities Code §§ 8530 to 8532.
The numbers you entered are within a limit listed below.
Savings and month table in the full calculator
What is specific to California
Who the author says the law is for
Sen. Scott Wiener's statement to the Assembly Utilities and Energy Committee said plug-in systems open solar to renters, condo owners and people with balconies, small backyards or patios. The law itself gives no right to install against a lease or an HOA rule, so ask your landlord or association first.
Because plug-in systems are small and portable, they expand the solar market, especially to renters, condo owners, and people with balconies, small backyards, or patios.
Where PG&E, SCE and SDG&E stood
The committee analysis for the June 10, 2026 hearing listed Pacific Gas and Electric as support if amended, and Southern California Edison and San Diego Gas and Electric as oppose unless amended. It said the utilities' concerns were mostly about safety and visibility. The bill changed after that hearing, so these positions are a snapshot.
Both IOUs and POUs raise a number of concerns with this approach, largely based on safety and visibility concerns.
Why your utility may ask you to register
The law lets a utility ask for a simple online registration, but not an approval. The Senate energy committee analysis from March 2026 gives the reason: opponents said utilities cannot see these systems, and that matters to line workers, grid planning and firefighters. If your utility sets up a form, that is where you tell it a device is at your address.
Many of the opponents to the bill express concerns that the lack of visibility of these systems will cause safety issues for electric lineman working on electrical circuits, utilities to plan their systems, and firefighters to respond to fires.
The older California law SB 868 did not touch
SB 868 says nothing about landlords or associations. An older law, Civil Code section 714, last amended in 2014, voids a covenant or a governing-document provision that prohibits or restricts a solar energy system, and it gives an association 45 days to deny an application in writing before the application counts as approved. The section still allows reasonable restrictions. It was written long before plug-in kits and never mentions one.
If an application is not denied in writing within 45 days from the date of receipt of the application, the application shall be deemed approved, unless that delay is the result of a reasonable request for additional information.
Whether a kit counts is not settled
Section 714 borrows its definition from Civil Code section 801.5. The definition turns on what a device is for, not on how it connects, and it names no plug, outlet or portable device. SB 868 uses a term of its own, portable solar generation device, and never says whether one is also a solar energy system. No California court decision or agency statement applying section 714 to a plug-in kit was found, so ask your association which rule it thinks applies.
Any solar collector or other solar energy device whose primary purpose is to provide for the collection, storage, and distribution of solar energy for space heating, space cooling, electric generation, or water heating.
The places the HOA law names, and the one it does not
Civil Code section 714.1 lists what an association may still do, such as approving what goes in a common area and asking an installer to cover damage. It also bars a blanket ban in three places: the roof of the building the owner lives in, and a garage or carport assigned to that owner. A balcony, a patio and a railing are not on that list, and a plug-in kit usually goes on one of those.
Establish a general policy prohibiting the installation or use of a rooftop solar energy system for household purposes on the roof of the building in which the owner resides, or a garage or carport adjacent to the building that has been assigned to the owner for exclusive use.
Sources for the local facts
- Assembly Committee on Utilities and Energy, analysis of SB 868 (Wiener), hearing of June 10, 2026, California State Assembly.
- Senate Committee on Energy, Utilities and Communications, analysis of SB 868, hearing of March 17, 2026, California State Senate.
- California Civil Code § 714, covenants restricting a solar energy system, California Legislative Information. leginfo refuses automated reads, so this was read in a browser. The section predates SB 868 and does not mention a plug-in or portable device.
- California Civil Code § 801.5, the definition of "solar energy system" that § 714 uses, California Legislative Information. leginfo refuses automated reads, so this was read in a browser.
- California Civil Code § 714.1, what an association may and may not do about a solar energy system, California Legislative Information. leginfo refuses automated reads, so this was read in a browser.
Expected output in California
Every California city this site covers is in the table, for an example kit of two 400 W panels on an 800 W inverter facing south. Each California figure is a long-term average of 2005 to 2015 satellite data, not a forecast. Your own panels, direction and shading change the result, so enter them in the California calculator above. The average residential electricity price in California (year-to-date through August 2026) is 32.58 cents per kWh. The rate on your bill may differ.
| City | Vertical (kWh) | Tilted (kWh) | Comparison bars |
|---|---|---|---|
| Los Angeles | 820 | 1,364 | |
| San Diego | 763 | 1,238 | |
| San Francisco | 833 | 1,335 |
Open the full calculator for Los Angeles · All states · Outlet and circuit checklist · Compare two kits
What the data say about California
Same example kit as the table above, on a railing. How California compares by direction and mounting
Common questions
When can I use balcony solar in California?
California's plug-in solar law, SB 868 (Chapter 985, Statutes of 2026), takes effect on January 1, 2027. The bill has no effective date clause, so it takes effect on the date the state constitution sets for a regular-session statute (Cal. Const. art. IV, § 8(c)). Its interconnection exemption and utility limits in § 8531 are repealed on January 1, 2030, the same day § 8532 starts barring the sale of plug-in devices that miss the law's code, certification and isolation conditions.
Does PG&E allow plug-in solar?
From January 1, 2027, PG&E, an investor-owned utility, may not require its approval, any fee or charge, or extra controls or equipment for a device that meets the law's conditions (§ 8531(b)). It may require a simple online registration of the device's address, make, model and size, and that registration cannot become an approval step (§ 8531(c)). The same rule covers Southern California Edison and every local publicly owned electric utility. PG&E's plug-in solar page, dated October 14, 2026, asks customers to send the installation address, the make and model, and the size of the system by email to plugin_solar@pge.com, with an online form planned from January 1, 2027.
Does California's law name UL 3700?
No. The law asks for a device "certified as a plug-in photovoltaic system" by Underwriters Laboratories or an equivalent nationally recognized testing laboratory, and names no standard number. It also asks for a certified feature that isolates the device from the building's electrical system so it cannot backfeed the grid during a power outage.
Last updated .