Signed, takes effect January 1, 2027
New Hampshire plug-in solar law: limits, dates and what to tell the utility
New Hampshire has signed a plug-in solar law that takes effect on January 1, 2027. The limit is 1,200 W. Each metered customer may have one plug-in solar generation system of up to 1,200 W AC maximum inverter output. The law does not require a notice, but it lets the utility ask for one or set up a way to register. Check with your utility. This page cannot check your lease, HOA rules, local codes or wiring.
1,200 WLimit on inverter output, in AC watts
- limit tier
- 1
- signed, 2026
- Jul 2
- takes effect, 2027
- Jan 1
- rules last checked
- Oct 1
Notice: none in the law, but the utility may ask for one.
Statute: SB 540-FN (2026), Chapter 262, Laws of 2026, RSA 362-A:1-a IV-a and RSA 362-A:10.
The law in New Hampshire
Plug-in solar generation system, one per metered customer (RSA 362-A:10): limit 1,200 W.
Dates: signed July 2, 2026, takes effect January 1, 2027.
Source: SB 540-FN (2026), Chapter 262, Laws of 2026, RSA 362-A:1-a IV-a and RSA 362-A:10, checked October 1, 2026. Update log
Conditions in New Hampshire's law
| Condition | In New Hampshire | Source |
|---|---|---|
| The device plugs into an outlet. It is not hardwired. | A receptacle or other non-permanent wiring connection. | RSA 362-A:1-a, IV-a |
| One system per metered customer. | Each metered customer is allowed a maximum of one plug-in solar generation system. | RSA 362-A:10, IV |
| The device must meet the certification or listing requirement in the law. | Certified by a nationally recognized testing laboratory to applicable safety standards. No standard number named. | RSA 362-A:10, I |
| The device must be intended to offset the customer's own use of electricity at the property. | Intended to exclusively offset a portion of onsite consumption. | RSA 362-A:1-a, IV-a |
| The law does not itself make the customer notify the utility, but the utility may ask for a notice or registration. Check your utility. | The utility may develop a method for the customer to report the wattage after installation, for notification purposes only. | RSA 362-A:10, II |
| What the law says about building, fire and local codes. Being exempt from the utility's interconnection rules is not, by itself, an exemption from them. | The state building code and manufacturer instructions. This section is not in force until a Department of Energy certification is filed. | RSA 155-A:16, II |
What New Hampshire's law does not settle
- Everything takes effect January 1, 2027 except section 3 (RSA 155-A:16, state building code), which waits for a Department of Energy commissioner certification that a national standard exists. No certification was found on October 1, 2026.
- Readings of that start date differ. The City of Dover tells its residents that use itself waits for the Department of Energy certification; this site reads section 7 of chapter 262 as holding back only section 3 and starting the rest on January 1, 2027. Either way RSA 362-A:10, I says plug-in solar generation systems "shall be certified by a nationally recognized testing laboratory to meet nationally recognized safety standards applicable to distributed energy resources and plug-in solar generation systems". It names no standard number, so what meets it is read off a maker's own certification statement. Ask your own town and your utility before you buy.
- A utility may set up a way to report the device, but it does not have to, and the report is for notice only.
- The law says nothing about landlords, HOAs or condo associations.
Beyond the limit in New Hampshire
Other terms in the law
- The utility may not require its approval before you install or use the system, an interconnection review or agreement, any fee except charges the system incurs through its use, or utility-specified controls or equipment beyond what the system has built in. (RSA 362-A:10, III)
- The utility is not liable for damage, injury, or compensation or charges arising from a system a customer installs or uses. (RSA 374:1-b)
- The Department of Energy must keep a consumer web page on plug-in systems. It must say that connecting an unlisted system, or not following the state building code or the maker's instructions, may affect homeowners or renters insurance coverage. (RSA 362-A:10, V)
- Once the building code section takes effect, the building code review board must amend the state building code to address buildings where a plug-in system is used. (RSA 155-A:16, I)
Power sent back to the grid
The law sets no net metering or export payment rule for plug-in systems. It requires the state Department of Energy to publish a consumer page covering meter compatibility and effects on billing. Net metering in every state
Permits and codes
A system must be installed and operated in accordance with the state building code and the manufacturer's instructions. That section is not in force until the Department of Energy files a certification, which the official RSA page did not show on October 2, 2026. The rest of the law starts on January 1, 2027. Source: RSA 155-A:16. Permits in every state
Renters, landlords and associations
The plug-in law says nothing about tenants, landlords, homeowner associations or condominium associations. Source: SB 540 (2026), Chapter 262. Renters and associations in every state
Check your own kit in New Hampshire
Estimate for your kit. Not a safety check: ask a licensed electrician about your wiring and outlets.
Expected output in Manchester, NH
Under New Hampshire's 1,200 W figureYour inputs
- Location
- Manchester, NH
- Inverter AC rating
- 800 W
- Panels
- 2 x 400 W = 800 W
- Panels in series
- 1
- Direction
- South
- Mounting
- Vertical (on a railing or wall, 90 degrees)
- Rate
- 26.91 cents per kWh
- Used at home
- 100%
Output by month (kWh)
Your kit against New Hampshire's limit
The law is signed but not yet in force: it takes effect on January 1, 2027. SB 540-FN (2026), Chapter 262, Laws of 2026, RSA 362-A:1-a IV-a and RSA 362-A:10.
The numbers you entered are within a limit listed below.
Savings and month table in the full calculator
What is specific to New Hampshire
Dover's electrical inspector urges caution
In September 2026 the City of Dover said its Energy Commission and its electrical inspector urge residents to be cautious with plug-in solar products until state safety standards are set. Dover is the home city of Sen. David Watters, a sponsor of SB 540. Ask your own town's building or electrical inspector before you install.
The Dover Energy Commission and the city’s electrical inspector urge the public to be cautious around the use plug-in solar products until these safety standards are established.
Towns may not unreasonably limit solar
The purpose section of New Hampshire's planning and zoning law says towns should not use zoning to unreasonably limit solar or other renewable energy systems, except where needed to protect public health, safety and welfare. It does not name plug-in devices, and it does not bind landlords or associations.
the installation of solar, wind, or other renewable energy systems or the building of structures that facilitate the collection of renewable energy shall not be unreasonably limited by use of municipal zoning powers or by the unreasonable interpretation of such powers except where necessary to protect the public health, safety, and welfare
More than one in four New Hampshire homes is rented
The Census Bureau counts 27.4% of New Hampshire's occupied homes as rented (American Community Survey, 2024). SB 540 says nothing about leases. The one place it mentions renters is the insurance notice the Department of Energy must publish, so a renter should check both the lease and the renters insurance policy.
Unitil asked for a registry and a cap
At the Senate hearing on January 8, 2026, Unitil asked for registration of devices and a limit on how many one person or property could connect, so utilities would know where devices are and what they produce. The committee's hearing report notes that Eversource also had concerns. The signed law keeps one system per metered customer and lets a utility set up a way to report a system's wattage, for notification only. If Unitil or Eversource serves your home, check its website from January 2027 for any such form.
He suggested establishing a cap or limit on how many devices a single individual or property can connect.
A question about the plug
The same hearing report records the chair of the state Building Code Review Board saying UL 3700, the test outline for plug-in solar, generally calls for a special connector, while the bill uses an ordinary outlet. The Department of Energy's director of enforcement told senators a shock can occur from the prongs when the plug is pulled out. The final law names no connector. Read the kit manual's steps for unplugging, and have an electrician look at the outlet you plan to use.
He noted that UL 3700 generally requires a unique or specialized connector, while the bill would require devices to be connected through a standard outlet.
Sources for the local facts
- Dover Energy Commission, electrical inspector urge caution for plug-in solar generation systems (September 2, 2026), City of Dover, New Hampshire.
- RSA 672:1, III-a, planning and zoning: declaration of purpose, New Hampshire General Court.
- American Community Survey 2024 1-year estimates, Table DP04, Selected Housing Characteristics: New Hampshire, U.S. Census Bureau.
- Hearing report, SB 540-FN, Senate Energy and Natural Resources Committee (hearing January 8, 2026), New Hampshire General Court. A committee staff summary of the Senate-stage bill, not a transcript.
Expected output in New Hampshire
Every New Hampshire city this site covers is in the table, for an example kit of two 400 W panels on an 800 W inverter facing south. Each New Hampshire figure is a long-term average of 2005 to 2015 satellite data, not a forecast. Your own panels, direction and shading change the result, so enter them in the New Hampshire calculator above. The average residential electricity price in New Hampshire (year-to-date through August 2026) is 26.91 cents per kWh. The rate on your bill may differ.
| City | Vertical (kWh) | Tilted (kWh) | Comparison bars |
|---|---|---|---|
| Manchester | 739 | 1,055 | |
| Nashua | 740 | 1,057 |
Open the full calculator for Manchester · All states · Outlet and circuit checklist · Compare two kits
What the data say about New Hampshire
Same example kit as the table above, on a railing. How New Hampshire compares by direction and mounting
Last updated .